Roberts MessageR Manual de usuario descargar pdf (Pagina 16)

Operating your radio - FM auto-tune

1. Fully extend the wire aerial located on the rear of your radio. Place

the wire antenna so that it is as straight as possible extending either

above or below the radio.

2. Press the On / Off button to switch on your radio.

3. Press and release the DAB / FM button until the FM band is selected.

4. Press and release the Auto Tune button to cause your radio to search

from low frequency to high frequency and to stop automatically when

it ﬁ nds a station of sufﬁ cient strength.

5. After a few seconds the display will update. The display will show the

frequency of the signal found. If the signal is strong enough and there

is RDS data present then the radio may display the station name.

6. To ﬁ nd other stations press and release the Auto Tune button as

before.

7. Press and hold down the Auto Tune button for 2 - 3 seconds to cause

your radio to search from high frequency to low frequency and to stop

automatically when it ﬁ nds a station of sufﬁ cient strength.

8. When the end of the waveband is reached your radio will recommence

tuning from the opposite end of the waveband.

9. Adjust the Volume to the required setting.

10. To switch off your radio, press the On / Off button.

4-7

2,10

Note:

If you ﬁ nd that FM reception is poor, try repositioning the wire aerial. Fully

extend the wire aerial located on the rear of your radio. Place the wire

antenna so that it is as straight as possible extending either above or

below the radio. If you ﬁ nd that an FM broadcast has a lot of background

hiss, this may often be reduced by setting the radio into Mono reception

mode for the current FM station. Please refer to the section "Stereo / Mono

setting - FM" on page 18 for further details.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

Sin comentarios

Roberts MessageR Manual de usuario Pagina 16